“USED” OMAX JET MACHINING CENTER 80160-40HP PUMP

1 OMAX 80160 Jet Machining Center 

X-Y table with motorized Z-Axis 

MAXJET 5 nozzle including all necessary high-pressure plumbing 

OMAX patented motion control software incorporating 

Windows XP Software 

600 lb. Abrasive Delivery System 

1 OMAX P4055V Direct Drive Pump 

Variable speed 40 HP electric motor for variable output maintenance 

Pressure safety blow down valve 

Charge pump include 

No in-rush current upon starting 

Pump seals cooking water is recycled 

Remote or local control 

Very easy access to all components for repair and maintenance 

1 MAXJET 5 Nozzle Start-up Kit 

2 mixing tubes 

1 diamond orifice 

2 orifices 

Blue Goop 

100lbs of abrasive garnet 

1 Pump Major Rebuild Kit 

Necessary components required for first dynamic seal change  

SPECIFICATION SUBJECT TO VERIFICATION 

OMAX recommends strict adherence to water quality and temperature requirements, as outfitted in this  proposal, for better performance and optimal operating cost. 

OMAX recommends a chiller for all OMAX units when the inlet water temperature exceeds 70°F